Course Outline:

A. Generator set Introduction

1. Generator Parts

2. Engine

3. Alternator

4. Battery Charger

5. Voltage Regulator

6. Control Panel

7. Jacket water heater

8. Fuel Tanks

9. Automatic Transfer Switch

10. Enclosure

B. Generator selection / sizing:

1. Types of Generators

2. Rating Definitions

3. Installations Procedure

4. Prepare generator compliance sheet and submittal.

C. Application and Installation

1. Foundation Block Design and Calculation

2. Electrical calculation

3. Noise

4. Air Requirements / Ventilation

5. Exhaust System Design and Calculation

6. Cooling System

7. Room Design 

8. ATS (Automatic Transfer Switch)

9. Electrical Panels

10. Cable Selection

11. Single Line Diagram

12. Exercise and exercise and exercise 

• Maintenance procedure

• Electrical schematic

• Control panel operation

• Commissioning Procedure 

• Safety Procedure 

• Discussions 

Training Outcomes

1. Understanding the principle of operation of the electrical generator.

2. Understanding the parts of the generators (electrical and mechanical).

3. Should be able to select the suitable generator for the exact load.

4. Select the right cable fro the generators.

5. Select the ATS rating and type.

6. Draw single line diagram.

7. Design and draw generators room.

8. Able to do a periodical maintenance for the generators.

9. Understanding the installation procedure.

10. Prepare the required calculation for the generators.

11. Able to prepare generator compliance sheet and submittal.

12. Able to read electrical drawing.

13. Understanding the difference between control panels and wiring.