KNX Smart Home Automation

Course Outline:

Part 1: Introducing to smart home

-        BENEFITS & ADVANTAGE

-        Solution

-        Type of Standard / Protocol

-        Z-GBEE, Z-WAVE, WIFI, BLUETOOTH

-        Comparison, what is the KNX Protocol?

Part 2: System arguments & overview

-        Why KNX?

-        What is the Job of KNX Association ?

-        Why chose KNX System ?

-        Configuration mode

-        Type Of control , ( Lighting , Shutter , AC , UFH )

Part 3: KNX devices

-        System component

-        Input / Sensor ( digital , Analog )

-        Output / Actuator / Gateway

( AC : Split , Ducted Split , VRF )

( Under floor Heating , MCC , Pumps )

( Lighting : on/off , universal dimming , Dali , 1-10 Dim , RGBW )

-        Study Data Sheet & AutoCAD Project Plan

-        Transmission Media (TP , PL , IP , RF)

-        Exercise 1

-        Power Supply and loop

-        Logic / controller

Part 4: KNX Installation

-        Type of cable

-        Installation of cable

-        Capacity & line segment

-        Back boxes & Height

-        Checking an installation

Part 5: System Topology

-        KNX AREA, LINE

-        Line coupler

-        Media coupler

-        Individual address

-        Back bone line , , IP router

-        Filter Table

-        Routing Counter

-        Exercise 1

-        Exercise 2

-        Design the KNX network

Part 6: Study, Selection, Design Drawing

-        Project 1: Study for villa (Requirement, BOQ) , From Scratch

-        Selection for devices

-        Make the offer

-        Design drawing via AutoCAD

-        Load schedule

-        Design Automation Panel via AutoCAD

-        Project 2: Study for tender project 

-        Reading Automation System Riser Diagrams

-        Selection for devices and make topology

Part 7: ETS planning, commissioning, diagnostics, Data Point, Telegram

-        Data Point Type

-        Telegram

-        Introduce for ETS software

-        Individual address, Testing via ETS diagnostics

-        Group address

-        Create project

-        Make the action via Link between Group object

-        Keypad, motion, switch, dimming, Scene, Stair case … Etc

-        Group monitor

Part 8: GRMS

-        Component

-        GRMS topology

-        Exercise

Part 9: System Integration with KNX

-        Intercom , CCTV , Sound